Unit 3 safety supervisor quiz

Unit 3 Safety supervisorQUESTION 1Which      of the following is NOT a factor in determine the frequency of      inspections?What is the potential for injury to employees?Are the employees repairing or adjusting equipment while   it is in motion?What is the past record of failure?How quickly can the item or part become hazardous?QUESTION 2When      should a safety and health inspection be conducted?WeeklyMonthlyBi-weeklyContinuouslyQUESTION 3Benefits      of a JSA include all of the following EXCEPT:making employee safety contacts.giving pre-job instructions on irregular jobs.mandating PPE usage.reviewing job procedures after the incidents occur.QUESTION 4What      is considered the last line of defense for protection from hazards?Engineering controlsAdministrative controlsPPERotation of workQUESTION 5An      audit is a methodical examination of a facility’s existing procedures and      practices to verify whether they comply with all of the following EXCEPT:legal requirements.internal policies.good practices.vehicle maintenance.QUESTION 6In      conducting inspections of production and related equipment, which of the      following would NOT fall into the category?WrenchesMillsPressesBordersQUESTION 7Which      of the following is an error that should be avoided when breaking aJSA down into steps?Observing the employee perform the taskCompletely describing each step of the processMaking the breakdown so detailed that an unnecessarily   large number of steps resultsVerify the breakdown with the person observed and obtain   agreementQUESTION 8The      best-practice approach to developing a safety and health committee      involvesgathering __________ representation by leaders and team members.as littleabundantequalappointedQUESTION 9Which      of the following is NOT a tip for successful meeting?KISSMeet in a comfortable placeMeet directly after a lunch periodPlan the agendaQUESTION 10Formal      inspections should be made routinely at least once a __________ or as      required by standards.weekmonthshiftyearDiscuss the Hierarchy of Controls found in Figure 6-2 of your textbook. Explain why it is this is a logical step in abating hazards?

"Looking for a Similar Assignment? Order now and Get 10% Discount! Use Code "Newclient"